Send documentation comments to mdsfeedback-doc@cisco.com
50-9
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
Configuring iSCSI
Figure 50-9 Dynamic Target Mapping
Note Each iSCSI initiator may not have access to all targets depending on the configured access control
mechanisms (see the “iSCSI Access Control” section on page 50-24).
To enable dynamic mapping of Fibre Channel targets into iSCSI using Device Manager, follow these
steps:
Step 1 Choose IP > iSCSI.
You see the iSCSI configuration (see Figure 50-10).
Figure 50-10 iSCSI Configuration in Device Manager
Step 2 Click the Targets tab to display a list of existing iSCSI targets (see Figure 50-11).
Figure 50-11 iSCSI Targets Tab
Step 3 Check the Dynamically Import FC Targets check box.
Step 4 Click Apply to save this change.
iSCSIiSCSI
IP host A
iqn.host A
IP Network
MDS-mgntIP
LUN0
LUN1
LUN2
LUN0
LUN1
LUN2
iSCSI
1/1
Virtual iSCSI Target
iqn.1987-05.com.cisco:05.<mgnt-IPaddr>.01-01.3100112233445566
pwwn 31.00.11.22.33.44.55.66
120780
To Next Page
Loading...
Need help?
General
