Cisco AP775A - Nexus Converged Network Switch 5010 User Manual

Send documentation comments to mdsfeedback-doc@cisco.com
50-64
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 50 Configuring iSCSI
iSCSI Authentication Setup Guidelines and Scenarios
c. Select ipaddress from the Initiator ID Mode drop-down menu and click the Apply Changes icon.
d. In Device Manager, choose Interfaces > Ethernet and iSCSI.
e. Click the iSCSI tab.
f. Select up from the Admin drop-down menu for the iSCSI interface in slot 7 port 1.
g. Click Apply.
Step 5 Configure the Gigabit Ethernet interface in slot 7 port 5 with the IPv4 address and enable the interface.
a. In Fabric Manager, choose Switches > Interfaces > Gigabit Ethernet in the Physical Attributes
pane.
b. Click the IP Address tab in the Information pane and click Create Row.
c. Set the IP address and subnet mask for the Gigabit Ethernet interface in slot 7 port 5.
d. Click Create.
e. Select the General tab and select up from the Admin drop-down menu for the Gigabit Ethernet
interface in slot 7 port 5.
f. Click the Apply Changes icon.
Step 6 Configure the iSCSI interface in slot 7 port 5 to identify all dynamic iSCSI initiators by IP address and
enable the interface.
a. In Fabric Manager, choose Switches > Interfaces > FC Logical in the Physical Attributes pane.
b. Click the iSCSI tab in the Information pane.
c. Select ipaddress from the Initiator ID Mode drop-down menu and click the Apply Changes icon.
d. In Device Manager, choose Interfaces > Ethernet and iSCSI.
e. Click the iSCSI tab.
f. Select up from the Admin drop-down menu for the iSCSI interface in slot 7 port 5.
g. Click Apply.
Step 7 Configure for static pWWN and nWWN for host 1.
a. In Device Manager, choose IP > iSCSI.
b. Click the Initiators tab.
c. Check the Node Address Persistent and Node Address System-assigned check boxes the Host 1
iSCSI initiator.
d. Click Apply.
Step 8 Configure for static pWWN for Host 2.
a. In Device Manager, Choose IP > iSCSI.
b. Click the Initiators tab.
c. Right-click on the Host 2 iSCSI initiator and click Edit pWWN.
d. Select 1 from the System-assigned Num field and click Apply.
Step 9 View the configured WWNs.
Note The WWNs are assigned by the system. The initiators are members of different VSANs.
a. In Fabric Manager, choose End Devices > iSCSI in the Physical Attributes pane.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English