Send documentation comments to mdsfeedback-doc@cisco.com
2-35
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
Installing the Management Software
Step 1 Enter the IP address of the switch in the Address field of your browser.
You see the Installation window for Device Manager shown in Figure 2-15.
Figure 2-15 Device Manager Installation Window
Step 2 Click the Cisco Device Manager link.
You see the welcome to the management software setup wizard message in the Cisco Device Manager
Installer window shown in
Figure 2-16.
Figure 2-16 Welcome to the Management Software Setup Wizard Window
Step 3 Click Next to begin the Installation.
Step 4 Check the I accept the terms of the License Agreement check box and click Next.
To Next Page
Loading...
Need help?
General
