Send documentation comments to mdsfeedback-doc@cisco.com
10-5
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 10 Obtaining and Installing Licenses
Licensing Model
SAN extension over IP package for IPS-8
modules
(SAN_EXTN_OVER_IP)
SAN extension over IP package for IPS-4
modules
(SAN_EXTN_OVER_IP_IPS4)
The following features apply to IPS-8 and IPS-4
modules:
• FCIP
• FCIP compression
• FCIP write acceleration
• FCIP tape read acceleration
• SAN extension tuner features
• IVR over FCIP
• IVR NAT over FCIP
• Network Stimulator
SAN extension over IP package for
MPS-14/2 modules
(SAN_EXTN_OVER_IP_IPS2)
Note The FCIP, IVR, and SAN extension
tuner features are bundled with the
Cisco MDS 9216i switch and do not
require the SAN extension over IP
package to be installed for the fixed
IP ports on the integrated supervisor
module. You must install a SAN
extension over IP package if you
install an MPS-14/2, IPS-8, or IPS-4
module in the Cisco MDS9216i
switch.
The following features apply to the MPS-14/2 module
and the fixed Cisco MDS 9216i IP ports:
• FCIP
• Hardware-based FCIP compression
• FCIP write acceleration
• FCIP tape read acceleration
• SAN extension tuner features
• IVR over FCIP
• IVR NAT over FCIP
SAN extension over IP package for one
MPS-18/4 or one MPS-18/4 FIPS in the
Cisco MDS 9500 series
(SAN_EXTN_OVER_IP_18_4)
The following features apply to the MPS-18/4 or
MPS-18/4 FIPS modules:
• FCIP
• Hardware-based FCIP compression
• FCIP write acceleration
• FCIP tape read acceleration
• SAN extension tuner features
• IVR over FCIP
• IVR NAT over FCIP
Table 10-1 Feature-Based Licenses (continued)
Feature License Features
To Next Page
Loading...
Need help?
General
