Send documentation comments to mdsfeedback-doc@cisco.com
16-6
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 16 Managing Configuration Files
Using the File System
Figure 16-7 Flash Files Dialog Box
Step 2
Select the device and partition from the drop-down lists for the directory containing the file you want to
copy.
Step 3 Click Copy.
You see the Copy dialog box shown in Figure 16-8.
Figure 16-8 Copy Flash Files in Device Manager
Step 4
Choose the protocol you want to use for the copy process: tftp, ftp, scp, or flashToFlash.
Step 5 Enter the address of the source server for a flash to flash copy only.
Step 6 Click the ... button to browse for the source file on your local PC or on the server, depending on the type
of copy.
Note If you are copying from flash, the filename must be in the format:
[device>:][<partition>:]<file>
Where device is a value obtained from FlashDeviceName, partition is a value obtained from
FlashPartitionName and file is the name of a file in flash.
Step 7 Enter the Switch Destination File name. (See the note in Step 6.)
To Next Page
Loading...
Need help?
General
