Send documentation comments to mdsfeedback-doc@cisco.com
21-23
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 21 Configuring N Port Virtualization
Configuring NPV
Figure 21-19 Warning, not Enough Number of Ports.
Figure 21-20 Configuring NPV Associated Ports by the Manual Method.
Select the Manual method to manually create port pairs (see Figure 21-20.) Click on a satellite switch
and select the NP device port expanded under each of the NPV switches listed. Then select the required
F port on the NPIV core switch and click Add for them to pair.
To Next Page
Loading...
Need help?
General
