Send documentation comments to mdsfeedback-doc@cisco.com
43-7
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 43 Configuring Certificate Authorities and Digital Certificates
Configuring CAs and Digital Certificates
Figure 43-1 PKI RSA Key-Pair Information
Step 3 Click Create Row.
You se e t he Create RSA Key-Pair dialog box shown in Figure 43-2.
Figure 43-2 Create RSA Key-Pair Dialog Box
Step 4 Select the switches for which you want to create the RSA key-pair.
Step 5 Assign a name to the RSA key-pair.
Step 6 Select the Size or modulus values. Valid modulus values are 512, 768, 1024, 1536, and 2048.
Note The security policy (or requirement) at the local site (MDS switch) and at the CA (where
enrollment is planned) are considered in deciding the appropriate key modulus.
Note The maximum number of key-pairs you can configure on a switch is 16.
Step 7 Check the Exportable check box if you want the key to be exportable.
Caution The exportability of a key-pair cannot be changed after key-pair generation.
Note Only exportable key-pairs can be exported in PKCS#12 format.
To Next Page
Loading...
Need help?
General
