Send documentation comments to mdsfeedback-doc@cisco.com
2-11
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
Initial Setup Routine
Enabled SSH service? (yes/no) [n]: yes
Step 12 Enter the SSH key type (see the “Generating the SSH Server Key Pair” section on page 39-17) that you
would like to generate.
Type the SSH key you would like to generate (dsa/rsa/rsa1)? rsa
Step 13 Enter the number of key bits within the specified range.
Enter the number of key bits? (768 to 1024): 1024
Step 14 Enter no (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: no
Step 15 Enter shut (shut is the default) to configure the default switch port interface to the shut state.
Configure default switchport interface state (shut/noshut) [shut]: shut
Note The management Ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
Step 16 Enter auto (off is the default) to configure the switch port trunk mode.
Configure default switchport trunk mode (on/off/auto) [off]: auto
Step 17 Enter deny (deny is the default) to deny a default zone policy configuration.
Configure default zone policy (permit/deny) [deny]: deny
Denies traffic flow to all members of the default zone.
Step 18 Enter no (no is the default) to disable a full zone set distribution (see the “Zone Set Distribution” section
on page 30-26).
Enable full zoneset distribution (yes/no) [n]: no
Disables the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Step 19 Enter no (no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
snmp-server community snmp_community rw
switchname switch
interface vsan1
ip address ip_address subnet_mask
no shutdown
ip default-gateway default_gateway
no telnet server enable
ssh key rsa 1024 force
ssh server enable
no system default switchport shutdown
system default switchport trunk mode auto
no zone default-zone permit vsan 1-4093
no zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]: no
Step 20 Enter yes (yes is default) to use and save this configuration.
Use this configuration and save it? (yes/no) [y]: yes
To Next Page
Loading...
Need help?
General
