Send documentation comments to mdsfeedback-doc@cisco.com
2-28
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
Installing the Management Software
Step 8 Click Finish to close the Cisco Fabric Manager Installer window.
To install (Custom) Fabric Manager on Windows, follow these steps:
Step 1 Click the Install Management Software link.
Step 2 Choose Management Software > Cisco Fabric Manager.
Step 3 Click the Installing Fabric Manager link.
Step 4 Click the FM Installer link.
You see the welcome message in the Cisco Fabric Manager Installer window shown in Figure 2-6.
Figure 2-6 Welcome to the Management Software Setup Wizard
Step 5 Click the Custom radio button, and then click Next to begin the installation.
Step 6 Check the I accept the terms of the License Agreement check box, and then click Next.
You see the Install Options dialog box shown in Figure 2-7.