Send documentation comments to mdsfeedback-doc@cisco.com
2-33
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
Installing the Management Software
Step 17 Select the local interface, web server port or Fabric Manager server port and check the FC Alias and
SNMPv3 check boxes as desired. Click Install if you are installing Fabric Manager Server. You see the
installation progress in the Cisco Fabric Manager Installer window as shown in
Figure 2-13.
Note You can change the Fabric Manager Server port number to a port that is not used by any other
application.
Note You should verify that the Fabric Manager Server hostname entry exists on the DNS server,
unless the Fabric Manager Server is configured to bind to a specific interface during installation.
Note If you check the Use HTTPS Web Server check box, the Web Server Port field is grayed out
and the default port is 443.
Note If you select a specific IP address during installation and change the server host IP address, you
must modify the following two files that are all located in the $INSTALL/conf directory. Change
server.bindaddrs to the new IP address in the server.properties file and change
wrapper.app.parameter.4 to the new IP address in the FMServer.conf file.
Figure 2-13 Progress of Installation
Once the installation is finished, you see an installation completed message in the Cisco Fabric Manager
Installer window shown in
Figure 2-14.
To Next Page
Loading...
