Send documentation comments to mdsfeedback-doc@cisco.com
55-5
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 55 Configuring SCSI Flow Services and Statistics
SCSI Flow Services
Step 1 Expand End Devices and then select SSM Features in the Physical Attributes pane.
You see the Intelligent Storage Services configuration, showing the FCWA tab in the Information pane
shown in
Figure 55-4.
Figure 55-4 FCWA Tab
Step 2 Click Create Row in the Information pane to create a SCSI flow or click a row in the FCWA table to
modify an existing SCSI flow.
You see the FC Write Acceleration dialog box shown in Figure 55-5.
Figure 55-5 FC Write Acceleration Dialog Box
Step 3 Select the initiator and target WWNs and VSAN IDs and check the WriteAcc check box to enable Fibre
Channel write acceleration on this SCSI flow.
Step 4 (Optional) Enable SCSI flow statistics on this SCSI flow by checking the Enable Statistics check box.
Step 5 (Optional) Change the BufCount value to set the number of 2K buffers used by the SCSI target.
Step 6 Click Create to create this SCSI flow.
To Next Page
Loading...
Need help?
General
