Cisco AP775A - Nexus Converged Network Switch 5010 - Page 18

Send documentation comments to mdsfeedback-doc@cisco.com
Contents
xviii
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Configuring Module Interface Shared Resources 22-28
Configuration Guidelines for 48-Port, 24-Port, and 4/44-Port 8-Gbps Fibre Channel Switching
Modules 22-28
Migrating from Shared Mode to Dedicated Mode 22-29
Migrating from Dedicated Mode to Shared Mode 22-29
Configuration Guidelines for 48-Port and 24-Port 4-Gbps Fibre Channel Switching Modules 22-30
Migrating from Shared Mode to Dedicated Mode 22-30
Migrating from Dedicated Mode to Shared Mode 22-30
Configuration Guidelines for 12-Port 4-Gbps Switching Module Interfaces 22-31
Configuration Guidelines for 4-Port 10-Gbps Switching Module Interfaces 22-31
Configuring Port Speed 22-32
Configuring Rate Mode 22-33
Configuring Oversubscription Ratio Restrictions 22-34
Disabling Restrictions on Oversubscription Ratios 22-35
Enabling Restrictions on Oversubscription Ratios 22-37
Configuring Bandwidth Fairness 22-37
Enabling Bandwidth Fairness 22-38
Disabling Bandwidth Fairness 22-39
Upgrade or Downgrade Scenario 22-40
Taking Interfaces Out of Service 22-40
Releasing Shared Resources in a Port Group 22-41
Displaying SFP Diagnostic Information 22-41
Default Settings 22-43
CHAPTER 23 Configuring PortChannels 23-1
About PortChannels 23-1
About E PortChannels 23-2
About F and TF PortChannels 23-3
About PortChanneling and Trunking 23-3
About Load Balancing 23-4
About PortChannel Modes 23-6
Configuration Guidelines and Restrictions 23-7
Generation 1 PortChannel Restrictions 23-7
F and TF PortChannel Restrictions 23-8
PortChannel Configuration 23-9
About PortChannel Configuration 23-10
Configuring PortChannels Using the Wizard 23-11
Configuring the PortChannel Mode 23-16
About PortChannel Deletion 23-16