Send documentation comments to mdsfeedback-doc@cisco.com
28-3
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 28 Creating Dynamic VSANs
DPVM
Figure 28-1 DPVM Wizard Icon
You see the Select Master Switch page.
Step 2 Click the switch you want to be the master switch. This switch controls the distribution of the DPVM
database to other switches in the fabric.
Step 3 Click Next.
You see the AutoLearn Current End Devices page.
Step 4 (Optional) Click the Create Configuration From Currently Logged In End Devices check box if you
want to turn on autolearning.
Step 5 Click Next.
You see the Edit and Activate Configuration page.
Step 6 Verify the current or autolearned configuration. Optionally, click Insert to add more entries into the
DPVM config database.
Step 7 Click Finish to update the DPVM config database, distribute the changes using CFS, and activate the
database, or click Cancel to exit the DPVM Setup Wizard without saving changes.
Figure 28-2 DPVM Setup Wizard: Select Master Switch
Step 8
Select the switch you want to be the master switch. This switch controls the distribution of the DPVM
database to other switches in the fabric.
Step 9 Click Next.
You see the AutoLearn Current End Devices page as shown in Figure 28-3.
To Next Page
Loading...
Need help?
General
