Send documentation comments to mdsfeedback-doc@cisco.com
30-5
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 30 Configuring and Managing Zones
About Zoning
• Hard and soft zoning are implemented using the active zone set. Modifications take effect during
zone set activation.
• An FC ID or Nx port that is not part of the active zone set belongs to the default zone and the default
zone information is not distributed to other switches.
Note If one zone set is active and you activate another zone set, the currently active zone set is automatically
deactivated. You do not need to explicitly deactivate the currently active zone set before activating a new
zone set.
Figure 30-3 shows a zone being added to an activated zone set.
To Next Page
Loading...
Need help?
General
