EasyManua.ls Logo

Cisco AP775A - Nexus Converged Network Switch 5010

Cisco AP775A - Nexus Converged Network Switch 5010
1486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Send documentation comments to mdsfeedback-doc@cisco.com
2-6
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
Initial Setup Routine
b. Enter the SNMPv3 password (minimum of eight characters). The default is admin123.
SNMPv3 user authentication password: admin_pass
Step 7 Enter yes (no is the default) to configure the read-only or read-write SNMP community string.
Configure read-write SNMP community string (yes/no) [n]: yes
a. Enter the SNMP community string.
SNMP community string: snmp_community
Step 8 Enter a name for the switch.
Note The switch name is limited to 32 alphanumeric characters. The default is switch.
Enter the switch name: switch_name
Step 9 Enter yes (yes is the default) to configure out-of-band management.
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
a. Enter the mgmt0 IP address.
Mgmt0 IPv4 address: ip_address
b. Enter the mgmt0 subnet mask.
Mgmt0 IPv4 netmask: subnet_mask
Step 10 Enter yes (yes is the default) to configure the default gateway (recommended).
Configure the default-gateway: (yes/no) [y]: yes
a. Enter the default gateway IP address.
IPv4 address of the default gateway: default_gateway
Step 11 Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes,
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
a. Enter no (no is the default) at the in-band management configuration prompt.
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: no
b. Enter yes (no is the default) to enable IP routing capabilities.
Enable the ip routing? (yes/no) [n]: yes
c. Enter yes (no is the default) to configure a static route (recommended).
Configure static route: (yes/no) [n]: yes
Enter the destination prefix.
Destination prefix: dest_prefix
Type the destination prefix mask.
Destination prefix mask: dest_mask
Type the next hop IP address.
Next hop ip address: next_hop_address

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Related product manuals