Send documentation comments to mdsfeedback-doc@cisco.com
2-7
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
Initial Setup Routine
Note Be sure to configure the IP route, the default network IP address, and the default gateway IP
address to enable SNMP access. If IP routing is enabled, the switch uses the IP route and the
default network IP address. If IP routing is disabled, the switch uses the default gateway IP
address.
d. Enter yes (no is the default) to configure the default network (recommended).
Configure the default network: (yes/no) [n]: yes
Enter the default network IP address.
Note The default network IP address is the destination prefix provided in Step 11c .
Default network IP address [dest_prefix]: dest_prefix
e. Enter yes (no is the default) to configure the DNS IP address.
Configure the DNS IPv4 address? (yes/no) [n]: yes
Enter the DNS IP address.
DNS IPv4 address: name_server
f. Enter yes (default is no) to configure the default domain name.
Configure the default domain name? (yes/no) [n]: yes
Enter the default domain name.
Default domain name: domain_name
Step 12 Enter yes (no is the default) to enable Telnet service.
Enable the telnet server? (yes/no) [n]: yes
Step 13 Enter yes (no is the default) to enable the SSH service.
Enabled SSH server? (yes/no) [n]: yes
Step 14 Enter the SSH key type (see the “Generating the SSH Server Key Pair” section on page 39-17) that you
would like to generate.
Type the SSH key you would like to generate (dsa/rsa)? dsa
Step 15 Enter the number of key bits within the specified range.
Enter the number of key bits? (768 to 2048): 768
Step 16 Enter yes (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: yes
Configure clock? (yes/no) [n] :yes
Configure clock? (yes/no) [n] :yes
Configure timezone? (yes/no) [n] :yes
Configure summertime? (yes/no) [n] :yes
Configure the ntp server? (yes/no) [n] : yes
a. Enter the NTP server IP address.
NTP server IP address: ntp_server_IP_address
To Next Page
Loading...
