Send documentation comments to mdsfeedback-doc@cisco.com
2-8
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
Initial Setup Routine
Step 17 Enter noshut (shut is the default) to configure the default switch port interface to the shut state.
Configure default switchport interface state (shut/noshut) [shut]: noshut
Step 18 Enter on (on is the default) to configure the switch port trunk mode.
Configure default switchport trunk mode (on/off/auto) [on]: on
Step 19 Enter no (no is the default) to configure switchport port mode F.
Configure default switchport port mode F (yes/no) [n] : no
Step 20 Enter permit (deny is the default) to deny a default zone policy configuration.
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
Step 21 Enter yes (no is the default) to disable a full zone set distribution (see the “Zone Set Distribution” section
on page 30-26). Disables the switch-wide default for the full zone set distribution feature.
Enable full zoneset distribution (yes/no) [n]: yes
You see the new configuration. Review and edit the configuration that you have just entered.
Step 22 Enter no (no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
username user_name password user_pass role network-admin
snmp-server community snmp_community ro
switchname switch
interface mgmt0
ip address ip_address subnet_mask
no shutdown
ip routing
ip route dest_prefix dest_mask dest_address
ip default-network dest_prefix
ip default-gateway default_gateway
ip name-server name_server
ip domain-name domain_name
telnet server enable
ssh key dsa 768 force
ssh server enable
ntp server ipaddr ntp_server
system default switchport shutdown
system default switchport trunk mode on
system default port-channel auto-create
zone default-zone permit vsan 1-4093
zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]: no
Step 23 Enter yes (yes is default) to use and save this configuration:
Use this configuration and save it? (yes/no) [y]: yes
To Next Page
Loading...
