Cisco ONS 15454 Series - Page 30

Procedures
xxx
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
NTP-A30 Create Users and Assign Security 4-4
NTP-A25 Set Up Name, Date, Time, and Contact Information 4-4
NTP-A261 Set Power Monitor Thresholds 4-6
NTP-A169 Set Up CTC Network Access 4-7
NTP-A27 Set Up the ONS 15454 for Firewall Access 4-8
NTP-A28 Set Up Timing 4-9
NTP-A170 Create Protection Groups 4-10
NTP-A256 Set Up SNMP 4-12
NTP-A35 Verify Node Turn-Up 5-2
NTP-A124 Provision a Point-to-Point Network 5-3
NTP-A173 Point-to-Point Network Acceptance Test 5-4
NTP-A38 Provision a Linear ADM Network 5-6
NTP-A174 Linear ADM Network Acceptance Test 5-8
NTP-A40 Provision BLSR Nodes 5-10
NTP-A126 Create a BLSR 5-12
NTP-A175 Two-Fiber BLSR Acceptance Test 5-13
NTP-A176 Four-Fiber BLSR Acceptance Test 5-15
NTP-A178 Provision a Traditional BLSR Dual-Ring Interconnect 5-17
NTP-A179 Provision an Integrated BLSR Dual-Ring Interconnect 5-19
NTP-A44 Provision Path Protection Nodes 5-20
NTP-A177 Path Protection Acceptance Test 5-22
NTP-A216 Provision a Traditional Path Protection Dual-Ring Interconnect 5-24
NTP-A217 Provision an Integrated Path Protection Dual-Ring Interconnect 5-26
NTP-A180 Provision a Traditional BLSR/Path Protection Dual-Ring Interconnect 5-27
NTP-A209 Provision an Integrated BLSR/Path Protection Dual-Ring Interconnect 5-30
NTP-A224 Provision an Open-Ended Path Protection 5-31
NTP-A225 Open-Ended Path Protection Acceptance Test 5-33
NTP-A46 Subtend a Path Protection from a BLSR 5-36
NTP-A47 Subtend a BLSR from a Path Protection 5-37
NTP-A48 Subtend a BLSR from a BLSR 5-38
NTP-A172 Create a Logical Network Map 5-40
NTP-A127 Verify Network Turn Up 6-4
NTP-A181 Create an Automatically Routed DS-1 Circuit 6-6
NTP-A182 Create a Manually Routed DS-1 Circuit 6-11
NTP-A183 Create a Unidirectional DS-1 Circuit with Multiple Drops 6-14