Serviceability Tracing Packet Commands 1003
Default Configuration
Display of LACP traces is disabled by default.
Command Mode
Privileged EXEC mode.
Usage Guidelines
There are no usage guidelines for this command.
Example
console#debug lacp packet
debug mldsnooping
Use the debug mldsnooping command to trace MLD snooping packet reception and
transmission. The receive option traces only received MLD snooping packets and the transmit
option traces only transmitted MLD snooping packets. When neither keyword is used in the
command, then all MLD snooping packet traces are dumped. Vital information such as source
address, destination address, control packet type, packet length, and the interface on which the
packet is received or transmitted is displayed on the console. Use the “no” form of this
command to disable tracing of MLD Snooping packets.
Syntax
debug mldsnooping packet [ receive | transmit ]
no debug mldsnooping packet [ receive | transmit ]
Default Configuration
Display of MLD Snooping traces is disabled by default.
Command Mode
Privileged EXEC mode.
Usage Guidelines
There are no usage guidelines for this command.
Example
console#debug mldsnooping
To Next Page
Loading...
