Dell PowerConnect 8024 Cli Reference Guide

Layer 2 Commands 145
3
Layer 2 Commands
Introduction
The chapters that follow describe commands that conform to the OSI model data link layer
(Layer 2). Layer 2 commands provide a logical organization for transmitting data bits on a
particular medium. This layer defines the framing, addressing, and checksum functions for
Ethernet packets.
This section of the document contains the following topics:
• AAA Commands
• ACL Commands
• Address Table Commands
• Auto-VoIP Commands
• CDP Interoperability Commands
• Data Center Bridging Commands
• DHCP Layer 2 Relay Commands
• DHCP Snooping Commands
• Dynamic ARP Inspection Commands
• Ethernet Configuration Commands
• GVRP Commands
• IGMP Snooping Commands
• IGMP Snooping Querier Commands
• IP Addressing Commands
• IPv6 Access List Commands
• IPv6 MLD Snooping Querier Commands
• IP Source Guard Commands
• iSCSI Flow Acceleration Commands
• LACP Commands
• Link Dependency Commands

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries