Dell PowerConnect 8024 - Protocol; Name

Captive Portal Commands 891
User Guidelines
There are no user guidelines for this command.
name
Use the name command to configure the name for a captive portal configuration. Use the “no”
form of this command to remove a configuration name.
Syntax
name cp-name
no name
• cp-name —CP configuration name (Range: 1–32 characters).
Default Configuration
Configuration 1 has the name “Default” by default. All other configurations have no name by
default.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#name cp2
protocol
Use the protocol command to configure the protocol mode for a captive portal configuration.
Syntax
protocol { http | https }
Default Configuration
The default protocols mode is https.
Command Mode
Captive Portal Instance mode.