Dell PowerConnect 8024 - Cut-Through Mode; Hostname

System Management Commands 1071
Example
console#clear power average
cut-through mode
Use the cut-through mode command to enable the cut-through mode on the switch. The mode
takes effect on all ports on next reload of the switch. To disable the cut-through mode on the
switch, use the no form of this command.
Syntax
cut-through mode
no cut-through mode
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
No specific guidelines.
Example
console(config)#cut-through mode
The mode (enable) is effective from the next reload of
Switch/Stack.
hostname
Use the hostname command in Global Configuration mode to specify or modify the switch host
name. To restore the default host name, use the no form of the command.
Syntax
hostname name
no hostname
• name — The name of the host. (Range: 1–255 characters)