Dell PowerConnect 8024 Cli Reference Guide

348 Link Dependency Commands
User Guidelines
No specific guidelines
Example
console(config-linkDep-group-1)#depends-on port-channel 6
no depends-on port-channel
Use the no depends-on port-channel command to remove the dependent port-channels list.
Syntax
no depends-on port-channel port-channel-list
• port-channel-list — List of port-channel interfaces. Separate nonconsecutive ports with a
comma and no spaces. Use a hyphen to designate the range of ports. (Range: Valid port-
channel interface list or range)
Default Configuration
This command has no default configuration.
Command Mode
Link Dependency mode
User Guidelines
No specific guidelines
Example
console(config-linkDep-group-1)# no depends-on port-channel 6
show link-dependency
Use the show link-dependency command to show the link dependencies configured for a
particular group. If no group is specified, then all the configured link-dependency groups are
displayed.
Syntax
show link-dependency [group GroupId ]
• GroupId — Link dependency group identifier. (Range: Valid Group Id, 1–16)

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries