IPv6 Routing Commands 657
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example clears all entries in the IPv6 neighbor table.
console(config)#clear ipv6 neighbors
clear ipv6 statistics
Use the clear ipv6 statistics command in Privileged EXEC mode to clear IPv6 statistics for all
interfaces or for a specific interface, including loopback and tunnel interfaces. IPv6 statistics
display in the output of the show ipv6 traffic command.
Syntax
clear ipv6 statistics [vlan
vlan-id
| tunnel
tunnel-id
| loopback
loopback-id
]
•
vlan-id
— Valid VLAN ID.
•
tunnel-id
— Tunnel identifier. (Range: 0-7)
•
loopback-id
— Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example clears IPv6 statistics for VLAN 11.
console(config)#clear ipv6 statistics vlan 11
To Next Page
Loading...
