RADIUS Commands 435
console(config)#radius-server host acct 3.2.3.2
console(Config-acct-radius)#acct-port 56
auth-port
Use the auth-port command in RADIUS mode to set the port number for authentication
requests of the designated RADIUS server.
Syntax
auth-port
auth-port-number
•
auth-port-number
— Port number for authentication requests. (Range: 1 - 65535)
Default Configuration
The default value of the port number is 1812.
Command Mode
RADIUS mode
User Guidelines
User must enter the mode corresponding to a specific RADIUS server before executing this
command.
Example
The following example sets the port number 2412 for authentication requests.
console(config)#radius-server host 192.143.120.123
console(config-radius)#auth-port 2412
To Next Page
Loading...
