Dell PowerConnect 8024 - Show Ip Interface

IP Routing Commands 623
Default Time to Live........................... 30
Routing Mode................................... Disabled
IP Forwarding Mode............................. Enabled
Maximum Next Hops.............................. 2
show ip interface
Use the show ip interface command in Privileged EXEC mode to display all pertinent
information about one or more IP interfaces.
Syntax
show ip interface [vlan vlan-id | loopback loopback -id]
• vlan-id — Valid VLAN ID
•
loopback-id — Valid loopback ID. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following examples display all IP information and information specific to VLAN 15.
console#show ip interface
Management Interface:
IP Address..................................... 10.240.4.125
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.240.4.1
Burned In MAC Address.......................... 00:10:18:82:04:35
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Routing Interfaces: