544 802.1X Commands
show dot1x users
Use the show dot1x users command in Privileged EXEC mode to display 802.1X authenticated
users for the switch.
Syntax
show dot1x users [username
username
]
•
username
— Supplicant
username (Range: 1- 160 characters)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
EapolFramesTx The number of EAPOL frames of any type that have been transmitted
by this Authenticator.
EapolStartFramesRx The number of EAPOL Start frames that have been received by this
Authenticator.
EapolLogoffFramesRx The number of EAPOL Logoff frames that have been received by this
Authenticator.
EapolRespIdFramesRx The number of EAP Resp/Id frames that have been received by this
Authenticator.
EapolRespFramesRx The number of valid EAP Response frames (other than Resp/Id
frames) that have been received by this Authenticator.
EapolReqIdFramesTx The number of EAP Req/Id frames that have been transmitted by this
Authenticator.
EapolReqFramesTx The number of EAP Request frames (other than Rq/Id frames) that
have been transmitted by this Authenticator.
InvalidEapolFramesRx The number of EAPOL frames that have been received by this
Authenticator in which the frame type is not recognized.
EapLengthErrorFramesRx The number of EAPOL frames that have been received by this
Authenticator in which the Packet Body Length field is invalid.
LastEapolFrameVersion The protocol version number carried in the most recently received
EAPOL frame.
LastEapolFrameSource The source MAC address carried in the most recently received EAPOL
frame.
Field Description
To Next Page
Loading...
