Dell PowerConnect 8024 - Ipv6 Pimdm; Ipv6 Pimdm Hello-Interval

IPv6 Routing Commands 673
ipv6 pimdm
Use the ipv6 pimdm command to enable PIM-DM Multicast Routing Mode across the router in
global configuration mode or on a specific routing interface in interface mode. Use the “no”
form of this command to disable PIM-DM.
Syntax
ipv6 pimdm
no ipv6 pimdm
Default Configuration
IPv6 PIM-DM is disabled by default.
Command Mode
Global Configuration mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 pimdm
ipv6 pimdm hello-interval
The ipv6 pimdm hello-interval command is used to configure the PIM-DM Hello Interval for
the specified router interface. The Hello-interval is to be specified in seconds. Use the "no"
form of this command to reset the hello interval to the default.
Syntax
ipv6 pimdm hello-interval interval
no ipv6 pimdm hello-interval
• interval - The hello interval time in seconds (Range: 0–65535).
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface Configuration (VLAN) mode