Dell PowerConnect 8024 - Ip Icmp Error-Interval

948 Denial of Service Commands
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip icmp echo-reply
ip icmp error-interval
Use the ip icmp error-interval command to limit the rate at which IPv4 ICMP error messages
are sent. The rate limit is configured as a token bucket with two configurable parameters: Burst-
size and burst-interval.
To disable ICMP rate limiting, set burst-interval to zero. Use the “no” form of this command to
return burst-interval and burst-size to their default values.
Syntax
ip icmp error-interval burst-interval [ burst-size ]
no ip icmp error-interval
• burst-interval — How often the token bucket is initialized (Range: 0–2147483647
milliseconds).
•
burst-size — The maximum number of messages that can be sent during a burst interval
(Range: 1–200).
Default Configuration
Rate limiting is enabled by default.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
console(config)#ip icmp error-interval 1000 20