Dell PowerConnect 8024 - Ip Igmp Startup-Query-Interval

592 IGMP Commands
• count — The number of startup queries. (Range: 1-20)
Default Configuration
The default count value is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets for VLAN 15 the number of queries sent out on startup at 10.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp startup-query-count 10
ip igmp startup-query-interval
Use the ip igmp startup-query-interval command in Interface Configuration mode to set the
interval between general queries sent at startup on the interface.
Syntax
ip igmp startup-query-interval seconds
no ip igmp startup-query-interval
• seconds — Startup query interval. (Range: 1-300 seconds)
Default Configuration
The default interval value is 31 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets at 10 seconds the interval between general queries sent at startup for
VLAN 15.