DHCP Layer 2 Relay Commands 207
10
DHCP Layer 2 Relay Commands
This chapter explains the following commands:
• dhcp l2relay (Global Configuration) (Global Configuration)
• dhcp l2relay (Interface Configuration) (Interface Configuration)
•dhcp l2relay circuit-id
• dhcp l2relay remote-id
• dhcp l2relay trust
•dhcp l2relay vlan
dhcp l2relay (Global Configuration)
Use the dhcp l2relay command to enable layer 2 DHCP relay functionality. The subsequent
commands mentioned in this section can only be used when the L2-DHCP relay is enabled. Use
the "no" form of this command to disable L2-DHCP relay.
Syntax
dhcp l2relay
no dhcp l2relay
Default Configuration
DHCP L2 Relay is disabled by default.
Command Mode
Global Configuration.
User Guidelines
There are no user guidelines for this command.
Example
console(config)#dhcp l2relay
To Next Page
Loading...
