Dell PowerConnect 8024 - Ipv6 Mld Query-Interval; Ipv6 Mld Query-Max-Response-Time

664 IPv6 Routing Commands
ipv6 mld query-interval
The ipv6 mld query-interval command sets the MLD router's query interval for the interface.
The query-interval is the amount of time between the general queries sent when the router is
querying on that interface. Use the “no” form of this command to set the query interval to the
default.
Syntax
ipv6 mld query-interval query-interval
no ipv6 mld query-interval
• query-interval — Query interval (Range: 1–3600).
Default Configuration
The default query interval is 125 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld query-interval 130
ipv6 mld query-max-response-time
The ipv6 mld query-max-response-time command sets MLD query maximum response time for
the interface. This value is used in assigning the maximum response time in the query messages
that are sent on that interface. Use the “no” form of this command to set the maximum query
response time to the default.
Syntax
ipv6 mld query-max-response-time query-max-response-time
no ipv6 mld query-max-response-time
• query-max-response-time — Maximum query response time (Range: 0–65535 milliseconds).
Default Configuration
The default query maximum response time is 10 seconds.