Dell PowerConnect 8024 - Ip Mcast Boundary; Ip Mroute

706 Multicast Commands
• show ip pimsm rp mapping
ip mcast boundary
Use the ip mcast boundary command in Interface Configuration mode to add an administrative
scope multicast boundary specified by
groupipaddr and mask for which this multicast
administrative boundary is applicable.
groupipaddr is a group IP address and mask is a group IP
mask.
Syntax
ip mcast boundary groupipaddr mask
no ip mcast boundary groupipaddr mask
• groupipaddr — IP address of multicast group. Valid range is 239.0.0.0 to 239.255.255.255.
•
mask — IP mask of multicast group.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5
255.255.255.255
ip mroute
Use the ip mroute command to create a static multicast route for a source range. Use the "no"
form of this command to delete a static multicast route.
Syntax
ip mroute source-address source-mask rpf-address preference
no ip mroute source-address source