Dell PowerConnect 8024 Cli Reference Guide

642 IPv6 Multicast Commands
Default Configuration
IPv6 PIMSM is disabled on the router by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm
ipv6 pimsm (VLAN Interface config)
Use the ipv6 pimsm command in VLAN Interface configuration mode to administratively
enable PIM-SM multicast routing mode on a particular IPv6 router interface. Use the "no" form
of this command to disable PIM SM on an interface.
Syntax
ipv6 pimsm
no ipv6 pimsm
Default Configuration
PIM-SM is disabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 pimsm
ipv6 pimsm bsr-border
Use the ipv6 pimsm bsr-border command to prevent bootstrap router (BSR) messages from
being sent or received through an interface. Use the "no" form of this command to disable the
interface from being the BSR border.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries