Dell PowerConnect 8024 - Show Ports Security Addresses

Address Table Commands 183
---- ------ ----------------- -------- ------- -------
1/g1 Locked Discard 3 Enable 100
1/g2 Unlocked - 28 - -
1/g3 Locked Discard, Shutdown 8 Disable -
The following table describes the fields in this example.
show ports security addresses
Use the show ports security addresses command in Privileged EXEC mode to display current
dynamic addresses in locked ports.
Syntax
show ports security addresses {ethernet interface |port-channel port-channel-number }
• interface — Valid Ethernet port
•
port-channel-number — Valid port-channel number
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Field Description
Port The port number.
Status The status can be one of the following: Locked or
Unlocked.
Actions Action on violations.
Maximum The maximum addresses that can be associated on this port
in Static Learning mode or in Dynamic Learning mode.
Trap Indicates if traps would be sent in case of violation.
Frequency The minimum time between consecutive traps.