562 DHCP and BOOTP Relay Commands
bootpdhcprelay maxhopcount
Use the bootpdhcprelay maxhopcount command in Global Configuration mode to configure
the maximum allowable relay agent hops for BootP/DHCP Relay on the system. Use the no
form of the command to set the maximum hop count to the default value.
Syntax
bootpdhcprelay maxhopcount
integer
no bootpdhcprelay maxhopcount
•
integer
— Maximum allowable relay agent hops for BootP/DHCP Relay on the system.
(Range: 1-16)
Default Configuration
The default
integer
configuration is 4.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example defines a maximum hopcount of 6.
console(config)#bootpdhcprelay maxhopcount 6
bootpdhcprelay minwaittime
Use the bootpdhcprelay minwaittime command in Global Configuration mode to configure
the minimum wait time in seconds for BootP/DHCP Relay on the system. When the BOOTP
relay agent receives a BOOTREQUEST message, it might use the seconds-sinceclient- began-
booting field of the request as a factor in deciding whether to relay the request or not. Use the
no form of the command to set the minimum wait time to the default value.
Syntax
bootpdhcprelay minwaittime
integer
no bootpdhcprelay minwaittime
•
integer
— Minimum wait time for BootP/DHCP Relay on the system. (Range: 0-100 seconds)
To Next Page
Loading...
