Dell PowerConnect 8024 Cli Reference Guide

600 IGMP Proxy Commands
console(config-if-vlan15)#ip igmp-proxy
ip igmp-proxy reset-status
Use the ip igmp-proxy reset-status command in Interface Configuration mode to reset the host
interface status parameters of the IGMP Proxy router. This command is valid only when IGMP
Proxy is enabled on the interface.
Syntax
ip igmp-proxy reset-status
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example resets the host interface status parameters of the IGMP Proxy router.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp-proxy reset-status
ip igmp-proxy unsolicited-report-interval
Use the ip igmp-proxy unsolicited-report-interval command in Interface Configuration mode
to set the unsolicited report interval for the IGMP Proxy router. This command is valid only if
IGMP Proxy on the interface is enabled.
Syntax
ip igmp-proxy unsolicited-report-interval seconds
• seconds — Unsolicited report interval. (Range: 1-260 seconds)
Default Configuration
The default configuration is 1 second.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries