Dell PowerConnect 8024 - Ip Ospf Transmit-Delay; Maximum-Paths

OSPF Commands 755
ip ospf transmit-delay
Use the ip ospf transmit-delay command in Interface Configuration mode to set the OSPF
Transit Delay for the specified interface. Use the no form of the command to return the delay to
the default value.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
• seconds — Sets the estimated number of seconds it takes to transmit a link state update
packet over this interface. (Range: 1–3600 seconds)
Default Configuration
1 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transit Delay for VLAN 15 at 20 seconds.
console(config-if-vlan15)#ip ospf transmit-delay 20
maximum-paths
Use the maximum-paths command in Router OSPF Configuration mode to set the number of
paths that OSPF can report for a given destination. Use the no form of the command to reset
the number to the default value.
Syntax
maximum-paths integer
no maximum-paths
• integer — Number of paths that OSPF can report for a given destination. (Range: 1–4.)
Default Configuration
4 is the integer default value.