EasyManuals Logo

Dell PowerConnect 8024 Cli Reference Guide

Dell PowerConnect 8024
1132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #863 background imageLoading...
Page #863 background image
Virtual Router Redundancy Protocol Commands 863
55
Virtual Router Redundancy Protocol
Commands
This chapter explains the following commands:
ip vrrp
ip vrrp authentication
ip vrrp ip
ip vrrp mode
ip vrrp preempt
ip vrrp priority
ip vrrp timers advertise
ip vrrp track interface
ip vrrp track ip route
show ip vrrp
show ip vrrp interface
show ip vrrp interface brief
show ip vrrp interface stats
ip vrrp
Use the ip vrrp command in Global Configuration mode to enable the administrative mode of
VRRP for the router. In Interface Config mode, this command enables the VRRP protocol on an
interface. Use the no form of the command to disable the administrative mode of VRRP for the
router.
Syntax (Global Config Mode)
ip vrrp
no ip vrrp
Syntax (Interface Config Mode)
ip vrrp
vr-id

Table of Contents

Other manuals for Dell PowerConnect 8024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 8024 and is the answer not in the manual?

Dell PowerConnect 8024 Specifications

General IconGeneral
Switching Capacity480 Gbps
StackableYes
Device TypeSwitch
Enclosure TypeRack-mountable
Power RedundancyOptional
Width17.3 in
Height1.7 in
Jumbo Frame SupportYes
Ports24 x 10 Gigabit SFP+
ManagementWeb-based GUI, Command Line Interface (CLI), SNMP
VLAN SupportYes
Power SupplyInternal
Routing ProtocolStatic routing
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature0 to 45 °C
Storage Temperature-20 to 70 °C
Relative Humidity10% to 90% (non-condensing)
MAC Address Table Size32, 000 entries

Related product manuals