Dell PowerConnect 8024 - Authentication Timeout; Captive-Portal

Captive Portal Commands 883
Captive Portal Global Commands
authentication timeout
Use the authentication timeout command to configure the authentication timeout. If the user
does not enter valid credentials within this time limit, the authentication page needs to be
served again in order for the client to gain access to the network. Use the “no” form of this
command to reset the authentication timeout to the default.
Syntax
authentication timeout timeout
no authentication timeout
• timeout —The authentication timeout (Range: 60–600 seconds).
Default Configuration
The default authentication timeout is 300 seconds.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#authentication timeout 600
console(config-CP)#no authentication timeout
captive-portal
Use the captive-portal command to enter the captive portal configuration mode.
Syntax
captive-portal
Default Configuration
There is no default configuration for this command.