Dell PowerConnect 8024 - Ip Telnet Server Disable

Telnet Server Commands 1111
73
Telnet Server Commands
This chapter explains the following commands:
• ip telnet server disable
•ip telnet port
•show ip telnet
ip telnet server disable
The ip telnet server disable command is used to enable/disable the Telnet service on the switch.
Syntax
ip telnet server disable
no ip telnet server disable
Parameter Ranges
Not applicable
Command Mode
Global Configuration
Usage Guidelines
No specific guidelines.
Default Value
This feature is enabled by default.
Example
console#configure
console(config)#ip telnet server disable
console(config)# no ip telnet server disable