230 Dynamic ARP Inspection Commands
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
The following fields are displayed for each interface:
Example
console#show ip arp inspection ethernet
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
--------------- ----------- ---------- ---------------
1/g1 Untrusted 15 1
1/g2 Untrusted 10 10
show ip arp inspection statistics
Use the show ip arp inspection statistics command to display the statistics of the ARP packets
processed by Dynamic ARP Inspection. Given vlan-range argument, it displays the statistics on
all DAI enabled Vlans in that range. In the case of no argument, it lists the summary of the
forwarded and dropped ARP packets.
Syntax
show ip arp inspection statistics [vlan
vlan-range
]
•
vlan-range
—A valid VLAN range.
Default Configuration
There is no default configuration for this command.
Interface The interface-id for each displayed row.
Trust State Whether interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.
To Next Page
Loading...
