Dell PowerConnect 8024 - Source-Ip; Timeout

450 RADIUS Commands
Access Rejects................................ 0
Access Challenges............................. 0
Malformed Access Responses.................... 0
Bad Authenticators............................ 0
Pending Requests.............................. 0
Timeouts...................................... 0
Unknown Types................................. 0
Packets Dropped............................... 0
source-ip
Use the source-ip command in RADIUS mode to specify the source IP address to be used for
communication with RADIUS servers. 0.0.0.0 is interpreted as a request to use the IP address of
the outgoing IP interface.
Syntax
source-ip source
• source — A valid source IP address.
Default Configuration
The IP address is of the outgoing IP interface.
Command Mode
RADIUS mode
User Guidelines
User must enter the mode corresponding to a specific RADIUS server before executing this
command.
Example
The following example specifies 10.240.1.23 as the source IP address.
console(config)#radius-server host 192.143.120.123
console(config-radius)#source-ip 10.240.1.23
timeout
Use the timeout command in RADIUS mode to set the timeout value in seconds for the
designated RADIUS server.