Dell PowerConnect 8024 - Show Ipv6 Mld-Proxy Groups Detail

688 IPv6 Routing Commands
Example
console#show ipv6 mld-proxy groups
Interface................................ vlan 10
Group Address Last Reporter Up Time Member State Filter Mode Sources
------------- -------------- ---------- ----------------- ------------ -------
FF1E::1 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 2
FF1E::2 FE80::100:2.3 00:02:40 DELAY_MEMBER Include 1
FF1E::3 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 0
FF1E::4 FE80::100:2.3 00:02:44 DELAY_MEMBER Include 4
show ipv6 mld-proxy groups detail
Use the show ipv6 mld-proxy groups detail command to display information about multicast
groups that MLD Proxy reported.
Syntax
show ipv6 mld-proxy groups detail
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
The following parameters are displayed by this command:
Interface The interface number of the MLD-Proxy.
Group Address The IP address of the multicast group.
Last Reporter The IP address of the host that last sent a membership report for the current group
on the network attached to the MLD Proxy interface (upstream interface).
Up Time (in secs) The time elapsed in seconds since last created.
Member State Possible values are:
• Idle_Member—The interface has responded to the latest group membership
query for this group.
• Delay_Member—The interface is going to send a group membership report to
respond to a group membership query for this group.
Filter Mode Possible values are Include or Exclude.