Dell PowerConnect 8024 - Ipv6 Multicast

82 Command Groups
IPv6 Multicast
show ip route summary Shows the number of all routes, including best and non-
best routes.
PE
show ip stats Displays IP statistical information UE
show ip vlan Displays the VLAN routing information for all VLANs with
routing enabled.
PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
ipv6 pimsm (Global config) Administratively enables PIMSM for IPv6 multicast
routing.
GC
ipv6 pimsm (VLAN Interface
config)
Administratively enables PIM-SM multicast routing mode
on a particular IPv6 router interface.
IC
ipv6 pimsm bsr-border Prevents bootstrap router (BSR) messages from being sent
or received through an interface.
IC
ipv6 pimsm bsr-candidate Configures the router to announce its candidacy as a
bootstrap router (BSR).
GC
ipv6 pimsm dr-priority Sets the priority value for which a router is elected as the
designated router (DR).
IC
ipv6 pimsm hello-interval Configures the PIM-SM Hello Interval for the specified
interface.
IC
ipv6 pimsm join-prune-interval Configures the interface join/prune interval for the PIM-SM
router
IC
ipv6 pimsm register-threshold Configure the Register Threshold rate for the RP router to
switch to the shortest path.
GC
ipv6 pimsm rp-address Statically configures the RP address for one or more
multicast groups.
GC
ipv6 pimsm rp-candidate Configures the router to advertise itself as a PIM candidate
rendezvous point (RP) to the bootstrap router (BSR).
GC
ipv6 pimsm spt-threshold Configures the Data Threshold rate for the lasthop router
to switch to the shortest path.
GC
ipv6 pimsm ssm Defines the Source Specific Multicast (SSM) range of
multicast addresses.
GC
show ipv6 pimsm Displays global status of IPv6 PIMSM and its IPv6 routing
interfaces.
PE
show ipv6 pimsm bsr Displays the bootstrap router (BSR) information. PE
Command Description Mode*