Dell PowerConnect 8024 - Show Ip Igmp Groups

594 IGMP Commands
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays system-wide IGMP information.
console#show ip igmp
IGMP Admin Mode................................ Enabled
IGMP Router-Alert check........................ Disabled
IGMP INTERFACE STATUS
Interface Interface-Mode Operational-Status
--------- -------------- ----------------
vlan 3 Enabled Non-Operational
show ip igmp groups
Use the show ip igmp groups command in Privileged EXEC mode to display the registered
multicast groups on the interface. If detail is specified, this command displays the registered
multicast groups on the interface in detail.
Syntax
show ip igmp groups interface vlan vlanid [detail]
• vlan-id — Valid VLAN ID
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.