Dell PowerConnect 8024 - Ip Pimsm Spt-Threshold; Ip Pimsm Ssm

Multicast Commands 715
ip pimsm spt-threshold
The ip pimsm spt-threshold command is used to configure the Data Threshold rate for the last-
hop router to switch to the shortest path. Use the “no” form of this command to set the data
threshold to the default.
Syntax
ip pimsm spt-threshold threshold
no ip pimsm spt-threshold
• threshold — The threshold rate (Range: 0–2000 Kbps).
Default Configuration
The default data threshold is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pimsm spt-threshold 1000
ip pimsm ssm
The ip pimsm ssm command is used to define the Source Specific Multicast (SSM) range of IP
multicast addresses. Use the “no” form of this command to disable the SSM range.
Syntax
ip pimsm ssm {default | group-address group-mask }
no ip pimsm ssm
• default — Defines the SSM range access list to 232/8.
•
group-address group-mask — defines the SSM range.
Default Configuration
There is no SSM range defined by default.