672 IPv6 Routing Commands
Default Configuration
The default value for neighbor discovery reachable times is 0 milliseconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the router advertisement time at 5000 milliseconds to consider a
neighbor reachable after neighbor discovery confirmation.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd reachable-time 5000
ipv6 nd suppress-ra
Use the ipv6 nd suppress-ra command in Interface Configuration mode to suppress router
advertisement transmission on an interface.
Syntax
ipv6 nd suppress-ra
no ipv6 nd suppress-ra
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example suppresses router advertisement transmission.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd suppress-ra
To Next Page
Loading...
