484 Spanning Tree Commands
spanning-tree transmit hold-count
Use the spanning-tree transmit hold-count command to set the maximum number of BPDUs
that a bridge is allowed to send within a hello time window (2 seconds). Use the “no” form of
this command to reset the hold count to the default value.
Syntax
spanning-tree transmit hold-count [
value
]
no spanning-tree transmit hold-count
•
value
— The maximum number of BPDUs to send (Range: 1–10).
Default Configuration
The default hold count is 6 BPDUs.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the maximum number of BPDUs sent to 6.
console(config)#spanning-tree transmit hold-count 6
To Next Page
Loading...
