Dell PowerConnect 8024 - Ipv6 Mld Last-Member-Query-Count; Ipv6 Mld Last-Member-Query-Interval

IPv6 Routing Commands 661
ipv6 mld last-member-query-count
The ipv6 mld last-member-query-count command sets the number of listener-specific queries
sent before the router assumes that there are no local members on the interface. Use the “no”
form of this command to set the last member query count to the default.
Syntax
ipv6 mld last-member-query-count last-member-query-count
no ipv6 mld last-member-query-count
• last-member-query-count — Query count (Range: 1–20).
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-count 5
ipv6 mld last-member-query-interval
The ipv6 mld last-member-query-interval command sets the last member query interval for the
MLD interface, which is the value of the maximum response time parameter in the group-
specific queries sent out of this interface. Use the “no” form of this command to set the last
member query interval to the default.
Syntax
ipv6 mld last-member-query-interval last-member-query-interval
no ipv6 mld last-member-query-interval
• last-member-query-interval — The last member query interval (Range: 0–65535
milliseconds).
Default Configuration
The default last member query interval is 1 second.